Current Limiting Reactor, 250 Continuous Amps, 13800 VAC L-L,

42000 Available Amps, 21000 Fault Limit Amps, P/N KK-30

A current-limiting reactor is used when the prospective short-circuit current in a distribution or transmission system is calculated to exceed the interrupting rating of the associated switchgear. The inductive reactance is chosen to be low enough for an acceptable voltage drop during normal operation, but high enough to restrict a short circuit to the rating of the switchgear. The amount of protection that a current-limiting reactor offers depends upon the percentage increase in impedance that it provides for the system.
 
The main motive for using current-limiting reactors is to reduce short-circuit currents so that circuit breakers with lower short-circuit breaking capacity can be used. They can also be used to protect other system components from high current levels and to limit the inrush current when starting a large motor.

The customer application is shown below:

 

Current Limiting Reactor, Three Phase

The inductance calculations are shown below:

  • L-L = 13800 VAC
  • V L-N = 7967 VAC
  • Available Fault Current = 42000 Amps
  • Fault Current = 21000 Amps
  • Z system (based on Available Current) = 7967 / 42000 = 0.1897 Ohms
  • Z system (based on Designed Fault Current) = 7967 / 2100 = 0.3794 Ohms
  • Z needed = Square Root of (0.3794² – 0.1897²) = 0.3286 Ohms
  • Inductance = 0.3286 / (2 x 3.142 x 60) = 871 uH
  • Reactance Voltage Drop = 0.3286 Ohms x 250 Amps = 82.2 VAC
  • Percentage Voltage drop = 82.2 / 7967 = 1.03 %

Specifications:

A. CLR, 250 Amps continuous, 3 PH, 60 Hz, 13800 V, P/N KK-30
B. Available fault current: 42000 Amps
C. Fault current: 21000 Amps
D. Copper windings
E. Approvals: none
F. System shipping weight: 1500 lbs. or TBD
G. Three inductors in three separate indoor enclosures (68″H x 65″W x 44″D)
H. Calculated Inductance Value: 871 uH, 250 Amps continuous
I. Percentage Voltage Drop: 1.03 %

 

The detail of one Air Core Inductor, KK-30-1 is shown below. Three KK-30-1 are required for one CLR KK-30.

 

 

 KK-30-1. Three are required per system

 

Specifications:

  • Air Core Inductor, P/N KK-30-1
  • L (1, 2) = 96.3 uH
  • Continuous Current: 3000 Amps
  • Frequency: 60 Hz
  • Copper windings
  • Approvals: None
  • Copper bus bars are 6″ x 1/4″ thick
  • One CLR consists of three separate air core inductors in three indoor enclosures

 

The System consists of three inductors in three separate indoor enclosures. Indoor Enclosure Dimensions are 125″W x 100″H x 125″D

 

 

Three Inductors in three separate indoor enclosures

All our CLR’s are custom-built to order. To discuss your specific application, please call our phone number at (714) 624-4740, or send us an email at quote@lcmagnetics.com.